Six pin set in display case of 9-11 and America pins. READ the IMPORTANT NOTE below about rubber pins.
Hinged plastic display case measures approx. 4.5" x 4.5". It holds five rubber pins and one metal pin. All have a single spike on the back with rubber clutch on rubber pins and metal on metal pin.
Furled Flag: approx. 1" x .75". Rubber.
Red, White & Blue Patriotic Ribbon: approx. 1.25" x 2.25". Rubber.
Eagle "GOD BLESS AMERICA": APPROX. 1.5" X 1.25". Rubber.
9-11-01 US Flag over NYC skyline with Twin Towers: approx. 1.25" x 1.25". Rubber.
Statue of Liberty/ GOD BLESS AMERICA: approx. 1.75" x 1.75". Rubber.
UNITED WE STAND set plate at bottom: approx. 4.25" x 0.75". Metal pin with printed design honoring Fire and Police (Patrolmen). Back has TWO metal spikes and has metal clutches whereas rubber pins have rubber clutches.
IMPORTANT NOTE: 5 of the pins are rubber, and the bottom one is metal. Rubber pins need gentle handling. The material allows for a beautiful 3D effect but the backing is affixed weaker. The spike on the back is metal embedded in a rubber disc and then glued to main body of pin. You can NOT pull the pin out of clothing the same way as with a metal pin by grasping the sides or you will pull the rubber disc off the pin body. Either push the spike through the clothing from the other side when removing or reach under the pin and pull with pressure on the rubber disc, not the back of the pin face. No problem if you do detach the disk as you can just glue it back with a super glue. Remember not to put the rubber clutch on the spike while you are gluing as excess glue could permanently put the cap on tight. Allow it to dry for a day before putting the cap back on the spike.
